Electronics Forum | Mon Oct 14 19:59:17 EDT 2013 | hegemon
We do in fact see a reduction in soldering defects, most especially wetting issues for both parts and PWBs, tombstones, billboards, etc... As a CM we see all kinds of customer furnished material, some of it not in the greatest condition. Our best p
Electronics Forum | Wed Aug 04 18:57:26 EDT 1999 | Dreamsniper
| What oven temperature should be used to reflow solder (Sn63Pb37) on a PC board (0.075" to 0.100" thickness) in 5 to 10 minutes? | Hi Judy, In profiling you need an understanding of the reflow specs from the solder paste manufacturer then you nee
Electronics Forum | Tue May 16 14:49:57 EDT 2006 | james
I know this is an old one, but we still have problems on our heller oven with parts blowing off their pads. Our other oven does not do this and it is a conceptronics oven. We do not currently have the adjustable fan speed on our heller oven. My q
Electronics Forum | Wed May 21 13:26:46 EDT 2003 | Brian W.
Something else to keep in mind when you reflow using an IR (non-convection) oven. IR reflow is more susceptible to variations in board mass and coloration than convection ovens. Hi mass areas and dark colored parts will cause more variation in your
Electronics Forum | Mon Dec 16 10:05:29 EST 2002 | Grant Petty
Hi, Thanks for the info. We are reflowing the boards, but just barely. Sometimes we get the QFP in the middle of the copper area not reflowing, and it's pain. The joints are dry, and I am not sure if it's caused by lack of heat, or the flux going ba
Electronics Forum | Wed Aug 24 08:03:17 EDT 2005 | james
I need some help here. I just to see what suggestions anyone else has. Our Man. Eng. has 3 profiles on our 9 zone Heller Reflow oven. These are the profiles: 1. 120 140 150 150 180 200 215 250 220 29in per minute 2. 120 130 145 150 150 185 20
Electronics Forum | Tue Apr 25 09:43:35 EDT 2006 | TMC
I am in the process of profiling some 8"x10"x0.063" double sided boards in our 4 zone oven(4 top and 4 bottom heaters). Was wondering if I can create a profile so that the components on bottom side of a board do not reflow while the componets on top
Electronics Forum | Tue Jul 31 22:06:12 EDT 2007 | davef
We had no problems reflowing an assembly on Bergquist Thermal Clad. The assembly was small. So, we built it on a 8-up fixture. It stayed in the fixture from screen print, through pick and place, and into reflow. When the fixture came out of the r
Electronics Forum | Mon Oct 02 11:52:22 EDT 2023 | proceng1
We have these thin and flexible sheets of fiberglass that we sometimes use to send boards through reflow that can't ride the edge hold fingers. We've had these sheets for a decade at least and have no idea what they are or where they were purchased
Electronics Forum | Mon Jan 19 20:25:52 EST 1998 | Steve Gregory
| I have a problem! The solder on my pc boards look great comeing out | of my reflow oven. They go thrue the rest of the prossese | and at the end at the qc station it's cold or whitish or gray not shiny. | does any one have a idea on how to correct
Lewis and Clark is your #1 Pre-Owned Surface Mount and In-Circuit Test equipment supplier. We offer a variety of equipment solutions at a significant cost savings over new.
Manufacturer / Equipment Dealer / Broker / Auctions
18 Celina Ave., Unit 16
Nashua, NH USA
Phone: (603) 594-4229
